Our new air flow sensors with High Cost-Effective using MCU-Based design and it is better far than current normal circuit design in market. By using our self- designed Air flow meter calibration system, we can ensure high precision and good quality of our products.

It could meet customers’ continually increasing global performance and cost effective requirements and emissions regulations.

Key Features

•   Direct mass flow measurement
  
•  Calibration using programmable ROM
  
•   Accurate measurement for energy saving and emission control
  
•   Improvement of air temperature compensation
  
•   Fast response time
  
•   Low power consumption
  
•   Cost effective design
  
•   Signal output options: frequency, analog
  
•   Supply options: plug-in sensor only or with housing
  

Product Description

In order to comply with the vehicle emission limits demanded by law, it is necessary to maintain a high precision given air/fuel ratio. This requires sensors which precisely measure the actual air-mass flow and output a corresponding electrical signal to the open and closed loop control electronics.

INNOTEQ ‘s mass air flow sensor is designed for recording load on combustion engines with petrol and diesel fuel injection. It is installed in the air intake system between the air cleaner and the throttle device and, on supercharged engines, between the air cleaner and super-charger either as a plug-in sensor in an existing air-conduction part, such as the air cleaner housing or as a pre-assembled plug-in sensor module in cylinder housing. Depending on the required air flow rate of the combustion engine, various cylinder housing sizes are provided.